Installation

Follow the instructions below carefully to avoid any damages.

  1. Power down your Eurorack system before installing the module

  2. Locate a position in your rack to install the module. Ohmicide requires 14HP of space

  3. Connect the 10-pin connector to the module, making sure pins are aligned and most importantly that the red stripe on the ribbon cable matches the “RED” marking on the module as shown in the picture below

  4. Connect the 16-pin connector to your rack, and ensure that the red stripe on the ribbon cable matches the -12V pin on the header

  5. Position the module in the desired position in your rack

  6. Secure the module to the rack using the 4 supplied screws. Do not overtighten

  7. Power up your Eurorack system

../_images/power.svg